28850C
1.INSTALL BATTERY STATE SENSOR ASSEMBLY
Attach the 2 claws to install the battery state sensor assembly to the battery current sensor holder.
Attach the clamp and connect the engine wire to the battery state sensor assembly.
Connect the battery state sensor assembly connector.
Install the battery state sensor assembly to the auxiliary battery and tighten the nut.
Connect the No. 2 frame wire to the battery state sensor assembly with the nut.
When disconnecting the engine wire, some systems need to be initialized after the engine wire is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
65351A
2.INSTALL BATTERY HOLE COVER
58416K
3.INSTALL REAR NO. 2 FLOOR BOARD
58410B
4.INSTALL DECK BOARD ASSEMBLY