The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front frame assembly removal/installation are shown below.
After the power switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the power switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1.REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
23825
2.REMOVE FUEL DELIVERY GUARD
3.INSTALL ENGINE HANGERS
45319
4.REMOVE STEERING GEAR HEAT INSULATOR (for LHD)
5.DISCONNECT WIRE HARNESS
for LHD:
Click hereSteering>STEERING GEAR / LINKAGE>STEERING GEAR>REMOVAL
for RHD:
Click hereSteering>STEERING GEAR / LINKAGE>STEERING GEAR>REMOVAL
51100H
6.REMOVE FRONT FRAME ASSEMBLY
Remove the 3 nuts and separate the front engine mounting insulator from the front frame assembly.
Remove the 4 nuts and separate the rear engine mounting insulator from the front frame assembly.
7.REMOVE FRONT STABILIZER BAR WITH BRACKET
44250
8.REMOVE RACK AND PINION POWER STEERING GEAR ASSEMBLY
48069
9.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
Remove the 3 bolts, nut and front lower No. 1 suspension arm sub-assembly LH from the front frame assembly.
Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.
Remove the front lower arm bushing stopper from the front lower No. 1 suspension arm sub-assembly.
48068
10.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
Perform the same procedure as for the LH side.
17572B
11.REMOVE NO. 2 EXHAUST PIPE SUPPORT BRACKET
Remove the 2 bolts and No. 2 exhaust pipe support bracket from the front frame assembly.