The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR cooler assembly removal/installation are shown below.
1.DRAIN ENGINE COOLANT (for Engine)
G9200
2.REMOVE INVERTER WITH CONVERTER ASSEMBLY
25680
3.REMOVE EGR COOLER ASSEMBLY
| *1 | No. 3 Water By-pass Hose |
| *2 | No. 4 Water By-pass Hose |
Slide the 2 clips and disconnect the No. 3 water by-pass hose and No. 4 water by-pass hose from the EGR cooler assembly.
Remove the 5 bolts and EGR cooler assembly from the cylinder head sub-assembly and EGR valve assembly.
Remove the EGR valve gasket from the EGR valve assembly.
Remove the EGR cooler gasket from the EGR cooler assembly.