Home › Engine / Hybrid System › A25A-FXS (EMISSION CONTROL) › CANISTER (w/ Canister Pump Module)
RM3620E _51 Engine / Hybrid System _076503 A25A-FXS EMISSION CONTROL _0372419 CANISTER(w/ Canister Pump Module) A

A25A-FXS EMISSION CONTROL  CANISTER(w/ Canister Pump Module)  INSTALLATION  


PROCEDURE

Hide 77740R 1.INSTALL LEAK DETECTION PUMP SUB-ASSEMBLY

HINT:

Only perform this procedure when replacement of the leak detection pump sub-assembly is necessary.


a.
A405792

Attach the 2 claws to install a new leak detection pump sub-assembly to the charcoal canister sub-assembly.

NOTICE:
·

Do not allow foreign matter such as grease, oil or water to adhere to the O-ring.

·

Ensure that the claws are attached properly.




Hide 77740 2.INSTALL CANISTER (CHARCOAL CANISTER ASSEMBLY)

a.

Install the clip to the vehicle body.


b.
A433626

Attach the claw to install the canister (charcoal canister assembly) to the vehicle body as shown in the illustration.


c.

Attach the clip to connect the canister (charcoal canister assembly).


d.

Install the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


e.

Connect the purge line hose to the canister (charcoal canister assembly), and slide the clip to secure the hose.


f.
A433623C01
1.969,2.729 2.323,2.729 true 2.344,2.635 2.531,2.833 0.188,0.198 10 false *a
*a Retainer
V100135

Push
V100136

Push in


Push the fuel tank vent hose onto the canister (charcoal canister assembly) and push in the retainer to attach the lock claws.

NOTICE:
·

Check that there are no scratches or foreign matter around the connecting parts of the tube connector and pipe (canister (charcoal canister assembly)) before performing this work.

·

After connecting the fuel tank vent hose, check that the fuel tank vent hose is securely connected by pulling on the tube connector.




g.

Connect the leak detection pump sub-assembly connector.


h.
A433620C01
1.958,2.74 2.292,2.74 true 2.313,2.635 2.531,2.833 0.219,0.198 10 false *a
*a Retainer
V100135

Push
V100136

Push in


Push in the fuel tank vent hose sub-assembly onto the leak detection pump sub-assembly and push in the retainer to attach the lock claws.

NOTICE:
·

Check that there are no scratches or foreign matter around the connecting parts of the tube connector and pipe (leak detection pump sub-assembly) before performing this work.

·

After connecting the fuel tank vent hose sub-assembly, check that the fuel tank vent hose sub-assembly is securely connected by pulling on the tube connector.




Hide 58167A 3.INSTALL FRONT CENTER FLOOR COVER