Home › Engine / Hybrid System › A25A-FXS (EMISSION CONTROL) › CANISTER (w/o Canister Pump Module)
RM3620E _51 Engine / Hybrid System _076503 A25A-FXS EMISSION CONTROL _0372420 CANISTER(w/o Canister Pump Module) A

A25A-FXS EMISSION CONTROL  CANISTER(w/o Canister Pump Module)  INSTALLATION  


PROCEDURE

Hide 77740 1.INSTALL CANISTER (CHARCOAL CANISTER ASSEMBLY)

a.
A445210

Attach the claw to install the canister (charcoal canister assembly) to the vehicle body as shown in the illustration.


b.

Install the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


c.

Install the purge line hose to the purge line pipe, and slide the clip to secure the hose.


d.

Connect the vent line hose to the canister (charcoal canister assembly), and slide the clip to secure the hose.


e.

Push the fuel tank vent hose onto the canister (charcoal canister assembly) and push in the retainer to attach the lock claws.

NOTICE:
·

Check that there are no scratches or foreign matter around the connecting parts of the tube connector and pipe (canister (charcoal canister assembly)) before performing this work.

·

After connecting the fuel tank vent hose, check that the fuel tank vent hose is securely connected by pulling on the tube connector.




Hide 58167A 2.INSTALL FRONT CENTER FLOOR COVER