Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › PANORAMIC MOON ROOF SYSTEM
RM3620E _59 Vehicle Exterior _076526 SLIDING ROOF / CONVERTIBLE _0372466 PANORAMIC MOON ROOF SYSTEM C

SLIDING ROOF / CONVERTIBLE  PANORAMIC MOON ROOF SYSTEM  B2345  Motor Control Relay Stuck ON  


DESCRIPTION

This DTC will be stored if the operation of the sliding roof is suspended and a pulse input of 10 Hz or more is detected when the motor relay is off.

DTC No. Detection Item DTC Detection Condition Trouble Area
B2345 Motor Control Relay Stuck ON Position failure (When the sliding roof ECU (sliding roof drive gear assembly [sliding roof]) enters fail-safe mode due to a problem with the gear position) Sliding roof ECU (sliding roof drive gear assembly [sliding roof])

CAUTION / NOTICE / HINT

NOTICE:
·

If the sliding roof ECU (sliding roof drive gear assembly [sliding roof]) is removed and reinstalled or replaced, the sliding roof ECU (sliding roof drive gear assembly [sliding roof]) must be initialized.

Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>INITIALIZATION

·

DTC B2345 is stored in the sliding roof ECU (sliding roof drive gear assembly [sliding roof]).



PROCEDURE

1.CHECK FOR DTC
a.

Clear the DTCs.

Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>DTC CHECK / CLEAR

Body Electrical > Sliding Roof > Clear DTCs
50002 147

b.

Check for DTCs.

Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>DTC CHECK / CLEAR

Body Electrical > Sliding Roof > Trouble Codes
50001 147
OK:

DTC B2345 is not output.



Result:
Proceed to
OK
NG



OK

NG

REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY [SLIDING ROOF])