The main body ECU (multiplex network body ECU) and rain sensor communicate via LIN communication. The main body ECU (multiplex network body ECU) stores this DTC if communication becomes abnormal.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | DTC Output from |
|---|---|---|---|---|---|
| B1279 | Lost Communication with Humidity/Rain Sensor LIN | DTC Detection Condition:
Ignition switch ON (IG+ voltage 9.5 V or higher) Malfunction Status:
Communication malfunction with rain sensor Malfunction Duration:
Continues for 10 seconds or more |
·
Rain sensor ·
Harness or connector |
○ | Main body ECU (multiplex network body ECU) |
Inspect fuse for circuits related to this system before performing the following procedure.
Clear the DTC.
Click hereVehicle Exterior>WIPER / WASHER>WIPER AND WASHER SYSTEM>DTC CHECK / CLEAR
Turn the ignition switch to ON and wait for at least 10 seconds.
Check for DTCs.
Click hereVehicle Exterior>WIPER / WASHER>WIPER AND WASHER SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC B1279 is not output. | A |
| DTC B1279 is output. | B |
| DTC B1279 and DTC B1373 are output. | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
Disconnect the G43 main body ECU (multiplex network body ECU) connector.
Disconnect the P6 rain sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G43-3 (LIN3) - P6-3 (MPX) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Rain Sensor) |
Disconnect the rain sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| P6-2 (ES) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| P6-4 (SIG) - Body ground | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG