17750A
1.REMOVE AIR CLEANER INLET ASSEMBLY (for Gasoline Model)
53510
2.REMOVE HOOD LOCK ASSEMBLY
|
Bolt |
|
Connector |
w/ Courtesy Switch:
Disconnect the connector.
Remove the 3 bolts.
Detach the clamp and disconnect the hood lock control cable assembly to remove the hood lock assembly.
Do not bend the hood lock control cable assembly excessively.
53601
3.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Detach the claw in the direction (1) indicated by the arrow shown in the illustration.
Detach the guide in the direction (2) indicated by the arrow shown in the illustration and remove the hood lock control lever sub-assembly.
Detach the clamp and remove the hood lock control lever sub-assembly from the hood lock control cable assembly.
4.REMOVE FRONT WHEEL
53895B
5.REMOVE FRONT FENDER FRONT SPLASH SHIELD RH (for Long Type)
53895B
6.REMOVE FRONT FENDER FRONT SPLASH SHIELD RH (for Short Type)
76621D
7.REMOVE FRONT FENDER MUDGUARD RH (w/ Mudguard)
Use the same procedure described for the LH side.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>MUDGUARD>REMOVAL
51441
8.REMOVE NO. 1 ENGINE UNDER COVER
75601A
9.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH (except Off Road Package)
Use the same procedure described for the LH side.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>WHEEL OPENING MOULDING (for Front)>REMOVAL
75601A
10.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH (for Off Road Package)
Use the same procedure described for the LH side.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>WHEEL OPENING MOULDING (for Front)>REMOVAL
53875A
11.REMOVE FRONT FENDER LINER RH
53630
12.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY
| *a | String |
Tie a string to the end of the hood lock control cable assembly in the cabin.
Use a length of string long enough to pass through the engine compartment.
|
Remove in this Direction |
Remove the grommet as shown in the illustration.
Using a screwdriver with its tip wrapped with protective tape, detach the clamp and remove the hood lock control cable assembly.
| *1 | Hood Lock Control Cable Assembly | - | - |
Pull the hood lock control cable assembly into the engine room.
Do not pull off the string, because it is used during installation. Leave it on the vehicle.
Disconnect the string from the hood lock control cable assembly.