The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
| Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
|
|
| Auxiliary battery terminal is disconnected/reconnected
|
Perform steering sensor zero point calibration
|
Lane control system
|
( )
|
| Parking support brake system (for HV model)*
|
| Pre-collision system
|
| Memorize steering angle neutral point
|
Parking assist monitor system
|
( )
|
| Panoramic view monitor system (for HV model)
|
( )
|
| Reset back door close position
|
Power back door system (for HV model)
|
( )
|
| Power back door initialization
|
Power door lock control system
|
( )
|
| Replacement of inverter with converter assembly
|
Resolver learning
|
·
Slight vibration at a vehicle speed of 5 km/h (3 mph) or less
·
Shock or vibration during acceleration
|
( )
|
| Replacement of ECM
|
w/ Canister Pump Module:
Perform Vehicle Identification Number (VIN) registration
|
DTC P063051 is output
|
( )
|
w/o Canister Pump Module:
Perform Vehicle Identification Number (VIN) or frame number registration
|
( )
|
| Replacement of engine coolant temperature sensor
|
Inspection after repair
|
·
Engine start function, etc.
|
w/ Canister Pump Module:( )
w/ Canister Pump Module:( )
|