Home › Engine / Hybrid System › A25A-FXS (ENGINE CONTROL) › KNOCK SENSOR
RM3620E _51 Engine / Hybrid System _076383 A25A-FXS ENGINE CONTROL _0372618 KNOCK SENSOR A

A25A-FXS ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


HINT:

Perform "Inspection After Repair" after replacing the knock control sensor.



PROCEDURE

Hide 89615 1.INSTALL KNOCK CONTROL SENSOR

HINT:

Perform "Inspection After Repair" after replacing the knock control sensor.



a.
A424124C01
1.635,2.083 1.833,2.281 0.198,0.198 10 false *a 0.635,3.958 0.875,4.167 0.24,0.208 10 false *b 1.24,2.5 1.438,2.719 0.198,0.219 10 false *c 1.802,2.469 2.031,2.688 0.229,0.219 10 false *d
*a Top
*b Right of Vehicle
*c 15°
*d 5°


Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:
·

If the knock control sensor has been struck or dropped, replace it.

·

Make sure that the knock control sensor is in the correct position.




b.

Connect the knock control sensor connector.