Home › Engine / Hybrid System › M20A-FKS (ENGINE CONTROL) › MASS AIR FLOW METER
RM3620E _51 Engine / Hybrid System _076384 M20A-FKS ENGINE CONTROL _0372636 MASS AIR FLOW METER G

M20A-FKS ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

HINT:

Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.

Read the value of Data List item "Mass Air Flow Sensor" using the GTS.

NOTICE:

Perform the inspection of the mass air flow meter sub-assembly while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).


i.

Connect the GTS to the DLC3.


ii.

Start the engine.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine / Data List / Mass Air Flow Sensor.

Powertrain > Engine > Data List
Tester Display
Mass Air Flow Sensor
50003 372 215

v.

According to the display on the GTS, read the Data List when the engine is running.

Standard Condition:
GTS Display Condition Specified Condition
Mass Air Flow Sensor Idling (engine warmed up) 1.5 to 3.3 gm/sec
3000 rpm (without load) 8.0 to 13.0 gm/sec


If the result is not as specified, replace the mass air flow meter sub-assembly.

If the result is within the specified range, remove and inspect the mass air flow meter sub-assembly.

Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>MASS AIR FLOW METER>INSPECTION