This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
11401G
1.INSTALL CRANKSHAFT POSITION SENSOR
Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
If reusing the crankshaft position sensor, be sure to inspect the O-ring.
Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.
If the crankshaft position sensor has been struck or dropped, replace it.
Make sure that the O-ring is not cracked or moved out of place when installing the crankshaft position sensor.
Connect the crankshaft position sensor connector.
28100
2.INSTALL STARTER ASSEMBLY
for 1.2 kW Type:
Click hereEngine / Hybrid System>M20A-FKS (STARTING)>STARTER (for 1.2 kW Type)>INSTALLATION
for Transaxle CVT with Stop and Start System:
for Transaxle M/T with Stop and Start System:
3.INSPECT FOR ENGINE OIL LEAK