Home › Engine / Hybrid System › M20A-FKS (STARTING) › STARTER (for Transaxle M/T with Stop and Start System)
RM3620E _51 Engine / Hybrid System _076488 M20A-FKS STARTING _0372215 STARTER(for Transaxle M/T with Stop and Start System) A

M20A-FKS STARTING  STARTER(for Transaxle M/T with Stop and Start System)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.

Torque:
46 N*m (469 kgf*cm, 34 ft.*lbf)


b.

Connect the No. 2 engine wire to terminal 30 with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Close the terminal cap.


d.

Connect the starter assembly connector.


e.

Attach the clamp.


f.

Install the engine wire to the transaxle with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 11363A 2.INSTALL FLYWHEEL HOUSING SIDE COVER

a.
A434706

Align the protrusion with the cylinder block sub-assembly and attach the claw as shown in the illustration to install the flywheel housing side cover.

NOTICE:
·

Make sure the claw makes a click sound, indicating that it fits tightly.

·

Replace the flywheel housing side cover with a new one if the claw does not fit tightly or is deformed.




Hide 3.INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

Hide 17750A 4.INSTALL INLET AIR CLEANER ASSEMBLY

Hide 12601B 5.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL