Home › Engine / Hybrid System › CRUISE CONTROL › FRONT RADAR SENSOR SYSTEM
RM3620E _51 Engine / Hybrid System _076038 CRUISE CONTROL _0373066 FRONT RADAR SENSOR SYSTEM Y

CRUISE CONTROL  FRONT RADAR SENSOR SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Before performing troubleshooting for the front radar sensor system, perform troubleshooting for the pre-collision system.

Click hereVehicle Interior>PRE-COLLISION>PRE-COLLISION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.PRE-CHECK
2.PRE-CHECK
a.

Measure the auxiliary battery voltage with the ignition switch off.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.


b.

Check the fuses and relays.


c.

Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.


Result:
Proceed to
NEXT



NEXT

3.CHECK CAN COMMUNICATION SYSTEM*
3.CHECK CAN COMMUNICATION SYSTEM*
a.

Using the GTS, check that the CAN communication system is functioning normally.

for HV Model:

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for HV Model)>DIAGNOSIS SYSTEM

for Gasoline Model:

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for Gasoline Model)>DIAGNOSIS SYSTEM

OK:

CAN communication system is functioning normally.



Result:
Proceed to
OK
NG



OK

4.CHECK FOR DTC*

NG

4.CHECK FOR DTC*
a.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT RADAR SENSOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Front Radar Sensor > Trouble Codes
50001 429

b.

Make a note of any DTCs that are output.


Result:
Result Proceed to
DTCs are not output A
DTC C1A1100 is output B
DTCs other than C1A1100 are output C



A

5.CHECK VEHICLE CONTROL HISTORY*

B

C

7.RECONFIRM DTC OUTPUT*
5.CHECK VEHICLE CONTROL HISTORY*
a.

Using the GTS, check for Vehicle Control History.

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT RADAR SENSOR SYSTEM>VEHICLE CONTROL HISTORY

Body Electrical > Front Radar Sensor > Utility
Tester Display
Vehicle Control History (RoB)
50005 429 55

b.

Record any output Vehicle Control History.


Result:
Result Proceed to
Vehicle Control History codes are not output A
Vehicle Control History code X2026 or X2028 is output B
Vehicle Control History codes other than X2026 and X2028 are output C



A

B

GO TO VEHICLE CONTROL HISTORY (X2026 or X2028)

C

6.RECONFIRM VEHICLE CONTROL HISTORY*
6.RECONFIRM VEHICLE CONTROL HISTORY*
a.

Using the GTS, clear the Vehicle Control History.

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT RADAR SENSOR SYSTEM>VEHICLE CONTROL HISTORY

Body Electrical > Front Radar Sensor > Utility
Tester Display
Vehicle Control History (RoB)
50005 429 55

b.

Using the GTS, check for Vehicle Control History.

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT RADAR SENSOR SYSTEM>VEHICLE CONTROL HISTORY

Body Electrical > Front Radar Sensor > Utility
Tester Display
Vehicle Control History (RoB)
50005 429 55

Result:
Result Proceed to
Vehicle Control History codes are not output A
Vehicle Control History codes are output B



A

B

7.RECONFIRM DTC OUTPUT*
a.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT RADAR SENSOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Front Radar Sensor > Clear DTCs
50002 429

b.

Reproduce the vehicle conditions that were present when the DTCs that were noted were stored.

HINT:

Refer to each corresponding DTC for details on the detection conditions.

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT RADAR SENSOR SYSTEM>DIAGNOSTIC TROUBLE CODE CHART



c.

Recheck for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT RADAR SENSOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Front Radar Sensor > Trouble Codes
50001 429

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

5.CHECK VEHICLE CONTROL HISTORY*

B