Home › Engine / Hybrid System › A25A-FKS (COOLING) › WATER PUMP
RM3620E _51 Engine / Hybrid System _076659 A25A-FKS COOLING _0373119 WATER PUMP A

A25A-FKS COOLING  WATER PUMP  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 16032 1.INSTALL ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)

a.

Install a new gasket to the engine water pump assembly (water inlet housing).

HINT:

Be sure to clean the contact surfaces.



b.

Install the engine water pump assembly (water inlet housing) to the cylinder block assembly with the 4 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


c.

Connect the engine water pump assembly (water inlet housing) connector.


d.
A434812C01
2.542,0.406 2.844,0.406 2.844,0.406 3.021,1.323 true 1.99,1.635 2.146,1.635 2.146,1.635 2.917,1.365 true 2.344,0.302 2.531,0.5 0.188,0.198 10 true *a 1.74,1.531 1.938,1.74 0.198,0.208 10 true *b
*a Protrusion
*b Cutout


Align the protrusion of the engine water pump assembly (water inlet housing) with the cutout in the sensor wire clamp.


e.

Using an 8 mm socket wrench, connect the sensor wire to the engine water pump assembly (water inlet housing) with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


f.

Connect the sensor wire connector.


Hide 16031 2.INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY