w/ Panoramic view monitor system:
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the side television camera assembly removal/installation are shown below.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
87961
1.REMOVE OUTER MIRROR LH
2.REMOVE OUTER MIRROR COVER LH
8794BA
3.REMOVE NO. 3 OUTER MIRROR COVER LH
81740
4.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH
5.REMOVE OUTER MIRROR LIGHT BULB
|
Turn in this Direction |
Turn the bulb socket counterclockwise until the bulb socket stops and disconnect it.
|
Remove in this Direction |
Remove the outer mirror light bulb from the bulb socket.