The headlight ECU sub-assembly LH or headlight ECU sub-assembly RH stores a DTC if it detects an internal malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Note |
|---|---|---|---|---|---|
| B242C | Right Headlight ECU Malfunction | Detection condition:
The ignition switch is ON Malfunction status:
Headlight ECU sub-assembly RH internal malfunction Malfunction duration:
Maximum 15 minutes |
Headlight ECU sub-assembly RH | Headlight ECU sub-assembly RH | - |
| B242D | Left Headlight ECU Malfunction | Detection condition:
The ignition switch is ON Malfunction status:
Headlight ECU sub-assembly LH internal malfunction Malfunction duration:
Maximum 15 minutes |
Headlight ECU sub-assembly LH | Headlight ECU sub-assembly LH | - |
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>INITIALIZATION
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling or HL AutoLeveling (Sub) / Clear DTCs.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Wait for at least maximum 15 minutes.
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling or HL AutoLeveling (Sub) / Trouble Codes.
Check for DTCs.
DTC B242C and B242D are not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (DTC B242C is output) | B |
| NG (DTC B242D is output) | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C