Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
58410B
1.REMOVE DECK BOARD ASSEMBLY
58417H
2.REMOVE REAR NO. 3 FLOOR BOARD
58386
3.REMOVE REAR FLOOR FINISH PLATE
58460D
4.REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY
5.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
Remove the rear side of the deck trim side panel assembly LH so that the connector of the rear combination light assembly LH can be disconnected.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
81498
6.REMOVE REAR COMBINATION LIGHT COVER LH
|
Place Hands Here |
|
Protective Tape |
|
Remove in this Direction |
Apply protective tape as shown in the illustration.
Place your hand at the location shown in the illustration and detach the claw to remove the rear combination light cover LH.
7.REMOVE REAR COMBINATION LIGHT ASSEMBLY LH
Insert your hand between the deck trim side panel assembly LH and the body and disconnect the connector.
|
Protective Tape |
Apply protective tape around the rear combination light assembly LH.
Remove the 2 screws.
| *a | Pin |
| *b | Guide |
|
Place Hands Here |
|
Pull in this Direction |
Place your hand at the location shown in the illustration and pull the rear combination light assembly LH toward the rear of the vehicle to detach the pin and guide to disconnect it.
Pull the rear combination light assembly LH straight towards the rear of the vehicle to prevent the guide from becoming damaged.
|
Remove in this Direction |
Remove the grommet and pull out the wire harness.