1.INSTALL WIRING HARNESS CLAMP BRACKET
Install the 3 wiring harness clamp brackets and connect the clutch control solenoid wire with the 3 bolts.
Tighten the ground of the clutch control solenoid wire together with bolt A.
Connect the 3 clamps and 2 connectors and install the clutch control solenoid wire.
36100A
2.INSTALL TRANSFER AND TRANSAXLE SETTING STUD BOLT
for Automatic Transaxle: Click hereDrivetrain>UB80F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE ASSEMBLY>INSTALLATION
36100
3.INSTALL TRANSFER ASSEMBLY
| *1 | Union Nut Wrench |
| *a | Torque Wrench Fulcrum Length |
Clean the bolt holes.
Install the transfer assembly to the transaxle with the 8 nuts.
This torque value is effective when SST is straight to a torque wrench.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 30 mm (1.181 in.)) + SST (fulcrum length of 150 mm (5.906 in.)) + torque wrench (fulcrum length of 255 mm (10.039 in.)): 40.2 N*m (410 kgf*cm, 30 ft.*lbf)
12303
4.INSTALL REAR ENGINE MOUNTING BRACKET SUB-ASSEMBLY
for Automatic Transaxle: Click hereDrivetrain>UB80F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE ASSEMBLY>INSTALLATION
12371A
5.INSTALL REAR ENGINE MOUNTING INSULATOR
for Automatic Transaxle: Click hereDrivetrain>UB80F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE ASSEMBLY>INSTALLATION
37109
6.INSTALL NO. 1 PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY
Install the No. 1 propeller shaft heat insulator bracket sub-assembly with the 2 bolts.
37117
7.INSTALL PROPELLER SHAFT HEAT INSULATOR
for Automatic Transaxle: Click hereDrivetrain>UB80F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE ASSEMBLY>INSTALLATION
8.INSTALL TRANSAXLE ASSEMBLY
for Automatic Transaxle: Click hereDrivetrain>UB80F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE ASSEMBLY>INSTALLATION
9. DYNAMIC TORQUE VECTORING 4WD/AWD SYSTEM CALIBRATION
When the electro magnetic control coupling sub-assembly is replaced, Learning Value Initialization must be performed.
Click hereDrivetrain>GF2A (TRANSFER / 4WD / AWD)>DYNAMIC TORQUE VECTORING AWD SYSTEM>CALIBRATION