Use the same procedure as for the LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
55607
1.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
87103B
2.REMOVE BLOWER MOTOR WITH FAN SUB-ASSEMBLY
Disconnect the connector.
| *A | for LHD | *B | for RHD |
| *C | for Two Layer Blower Type | *D | for Single Layer Blower Type |
|
Screw |
|
Connector |
Remove the 3 screws and blower motor with fan sub-assembly.
Replace the blower motor with fan sub-assembly if it has been dropped or subjected to a severe impact.