The refreshing seat switch (seat heater switch) communicates with the air conditioning amplifier assembly via LIN communication.
If the LIN communication malfunctions, the seat heater system does not operate even if the refreshing seat switch (seat heater switch) is operated.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B14B5 | Lost Communication with Front Seat Temperature Adjustment Switch LIN | Lost communication with refreshing seat switch (seat heater switch) | ·
Harness or connector ·
Refreshing seat switch (seat heater switch) ·
Air conditioning amplifier assembly |
Inspect the fuse related to this system before inspecting the suspected areas below.
Clear the DTCs.
Click hereVehicle Interior>SEAT>SEAT HEATER SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereVehicle Interior>SEAT>SEAT HEATER SYSTEM>DTC CHECK / CLEAR
DTC B14B5 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
| *a | Front view of wire harness connector
(to Refreshing Seat Switch [Seat Heater Switch]) |
Disconnect the refreshing seat switch (seat heater switch) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G31-9 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| G31-9 (IG) - Body ground | Ignition switch off | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G31-7 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G31 refreshing seat switch (seat heater switch) connector.
Disconnect the G24 air conditioning control assembly connector.
Disconnect the G46 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G31-8 (SLIN) - G46-7 (LIN1) | Always | Below 1 Ω |
| G31-8 (SLIN) or G46-7 (LIN1) - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the refreshing seat switch (seat heater switch) with a new or known good one.
Click hereVehicle Interior>SEAT>SEAT HEATER SWITCH (for Front Seat)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Click hereVehicle Interior>SEAT>SEAT HEATER SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereVehicle Interior>SEAT>SEAT HEATER SYSTEM>DTC CHECK / CLEAR
DTC B14B5 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG