Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING VALVE › 2018.10–2019.09
RM3620E _53 Suspension _076850 TIRE PRESSURE MONITORING _0377452 TIRE PRESSURE WARNING VALVE A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING VALVE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the Tire pressure warning valve and transmitter removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model:)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Tire pressure warning valve and transmitter
·

Register transmitter ID

·

Initialize tire pressure warning system


·

When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

·

Tire pressure warning function


for Initialization:(Click here)
for Registration:(Click here)

Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model:)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Tire pressure warning valve and transmitter
·

Register transmitter ID

·

Initialize tire pressure warning system


·

When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

·

Tire pressure warning function


for Initialization:(Click here)
for Registration:(Click here)

PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.REMOVE REAR WHEEL

Hide 3.REMOVE FULL SIZE SPARE TIRE (w/ Full Size Spare Tire)

Hide 42607 4.REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER

a.

Remove the cap and valve core to release the air from the tire.

NOTICE:

Keep the removed cap.



b.

After ensuring that a sufficient amount of air has been released, remove the nut and washer used to secure the tire pressure warning valve and transmitter. Then drop the tire pressure warning valve and transmitter with the grommet into the tire.

HINT:

The grommet may remain attached to the rim.



c.
C180021C05
2.041,1.737 2.265,1.902 0.224,0.165 10 (A) 2.922,0.912 2.429,0.912 false 0.365,0.83 0.984,0.83 false 0.168,0.741 0.319,0.92 0.151,0.179 10 *1 2.953,0.833 3.12,0.991 0.167,0.158 10 *2
*1 Tire
*2 Shoe


After dropping the tire pressure warning valve and transmitter into the tire, disengage the bead using the shoe of a tire remover.

NOTICE:
·

Be careful as the tire pressure warning valve and transmitter may become damaged due to interference between the sensor and tire bead.

·

Set the tire remover shoe as shown in the illustration.

Width (A):

10 to 20 mm (0.394 to 0.787 in.)





d.

Separate the upper bead.


e.

Take out the tire pressure warning valve and transmitter with the grommet from the tire and separate the lower bead.


f.

Remove the grommet from the tire pressure warning valve and transmitter.