891B1
1.REMOVE KICK DOOR CONTROL BRACKET (w/ Hands Free Power Back Door)
82182
2.REMOVE NO. 2 LUGGAGE ROOM WIRE (w/ TOYOTA Parking Assist-sensor System)
Disconnect the 4 connectors.
Do not apply excessive loads to the retainer. Otherwise, it may peel off.
Detach the clamp and remove the No. 2 luggage room wire.
| *A | w/ Hands Free Power Back Door | - | - |
89342
3.REMOVE REAR CORNER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
89342A
4.REMOVE REAR CENTER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
89348R
5.REMOVE REAR CORNER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)
89348S
6.REMOVE REAR CENTER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)
52162A
7.REMOVE REAR BUMPER PIECE LH
Remove the 2 screws.
Remove the 3 outside moulding retainers.
|
Remove in this Direction |
Detach the guide and claw to remove the rear bumper piece LH.
52161A
8.REMOVE REAR BUMPER PIECE RH
Use the same procedure for the RH and LH side.
9.REMOVE SPRING NUT
|
Remove in this Direction |
Remove the 2 spring nuts.
Use the same procedure for the RH and LH side.
w/ Mudguard:
|
Remove in this Direction |
Remove the 2 spring nuts.
Use the same procedure for the RH and LH side.
81920
10.REMOVE REFLEX REFLECTOR ASSEMBLY LH
|
Remove in this Direction |
Remove the screw.
Detach the guide and remove the reflex reflector assembly LH.
81910
11.REMOVE REFLEX REFLECTOR ASSEMBLY RH
Use the same procedure for the RH and LH side.
52151E
12.REMOVE REAR BUMPER BAR
When removing the rear bumper bar, if the double-sided tape is difficult to remove, heat the adhesive of the rear bumper bar and rear bumper cover using a heat light.
| Item | Temperature |
|---|---|
| Rear Bumper Cover | 20 to 30°C (68 to 86°F) |
| Rear Bumper Bar | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rear bumper cover and rear bumper bar excessively.
Remove the rear bumper bar.
52461
13.REMOVE REAR BUMPER CENTER PAD (except Separate Type)
When removing the rear bumper center pad, if the double-sided tape is difficult to remove, heat the adhesive of the rear bumper center pad and rear bumper cover using a heat light.
| Item | Temperature |
|---|---|
| Rear Bumper Cover | 20 to 30°C (68 to 86°F) |
| Rear Bumper Center Pad | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rear bumper cover and rear bumper center pad excessively.
Remove the 3 rear bumper center pads.
52453
14.REMOVE REAR BUMPER CENTER GUARD (for Separate Type)
Remove the 4 outside moulding retainers.
Detach the guide and claw to remove the rear bumper center guard.
|
Remove in this Direction | - | - |
76829A
15.REMOVE BACK DOOR GARNISH RETAINER
Remove the back door garnish retainer.
Use the same procedure for the RH and LH side.
52463
16.REMOVE REAR BUMPER PAD LH
When removing the rear bumper pad LH, if the double-sided tape is difficult to remove, heat the adhesive of the rear bumper pad LH and rear bumper piece LH using a heat light.
| Item | Temperature |
|---|---|
| Rear Bumper Piece LH | 20 to 30°C (68 to 86°F) |
| Rear Bumper Pad LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rear bumper piece LH and rear bumper pad LH excessively.
Remove the rear bumper pad LH.
52463B
17.REMOVE REAR BUMPER PAD LH
When removing the rear bumper pad LH, if the double-sided tape is difficult to remove, heat the adhesive of the rear bumper pad LH and rear bumper piece LH using a heat light.
| Item | Temperature |
|---|---|
| Rear Bumper Piece LH | 20 to 30°C (68 to 86°F) |
| Rear Bumper Pad LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rear bumper piece LH and rear bumper pad LH excessively.
Remove the rear bumper pad LH.
52462
18.REMOVE REAR BUMPER PAD (for LH Side)
When removing the rear bumper pad, if the double-sided tape is difficult to remove, heat the adhesive of the rear bumper pad and rear bumper piece LH using a heat light.
| Item | Temperature |
|---|---|
| Rear Bumper Piece LH | 20 to 30°C (68 to 86°F) |
| Rear Bumper Pad | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rear bumper piece LH and rear bumper pad excessively.
Remove the rear bumper pad.
52462
19.REMOVE REAR BUMPER PAD (for RH Side)
When removing the rear bumper pad, if the double-sided tape is difficult to remove, heat the adhesive of the rear bumper pad and rear bumper piece RH using a heat light.
| Item | Temperature |
|---|---|
| Rear Bumper Piece RH | 20 to 30°C (68 to 86°F) |
| Rear Bumper Pad | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rear bumper piece RH and rear bumper pad excessively.
Remove the rear bumper pad.
52462C
20.REMOVE REAR BUMPER PAD RH
When removing the rear bumper pad RH, if the double-sided tape is difficult to remove, heat the adhesive of the rear bumper pad RH and rear bumper piece RH using a heat light.
| Item | Temperature |
|---|---|
| Rear Bumper Piece RH | 20 to 30°C (68 to 86°F) |
| Rear Bumper Pad RH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rear bumper piece RH and rear bumper pad RH excessively.
Remove the rear bumper pad RH.