The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the kick door control sensor removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
58410B
2.REMOVE DECK BOARD ASSEMBLY (for HV Model)
58416K
3.REMOVE REAR NO. 2 FLOOR BOARD (for HV Model)
65351A
4.REMOVE BATTERY HOLE COVER (for HV Model)
5.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for A25A-FXS:
Click hereGeneral>MAINTENANCE>A25A-FXS AUXILIARY BATTERY>REMOVAL
for A25A-FKS:
for M20A-FKS:
Click hereGeneral>MAINTENANCE>M20A-FKS BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
52159
6.REMOVE REAR BUMPER COVER
891B1
7.REMOVE KICK DOOR CONTROL BRACKET
Disconnect the connector.
Do not touch the terminal of the kick door control sensor connector.
Remove the 3 screws.
|
Remove in this Direction |
|
Screw |
|
Clip | - | - |
Remove the 2 clips and kick door control bracket together with the kick door control sensor.
891B2
8.REMOVE KICK DOOR CONTROL SENSOR
Detach the claw and guide and disconnect the antenna cable in the order shown in the illustration.
Detach the clamp.
Do not pull strongly on the wire.
Do not twist the wire.
|
Remove in this Direction |
Detach the claw in the direction indicated by the arrow as shown in the illustration.
|
Remove in this Direction |
Detach the guide and remove the kick door control sensor from the kick door control bracket in the direction indicated by the arrow shown in the illustration.
Do not subject the kick door control sensor to strong impacts or force, and do not drop it.
Do not reuse a kick door control sensor which has been subjected to an impact or dropped.