1.INSPECT 1ST GEAR THRUST CLEARANCE
2.INSPECT 2ND GEAR THRUST CLEARANCE
3.INSPECT 1ST GEAR RADIAL CLEARANCE
4.INSPECT 2ND GEAR RADIAL CLEARANCE
33429B
5.REMOVE 6TH DRIVEN GEAR
| *1 | Rear Output Shaft Bearing (Inner Race) |
| *2 | 6th Driven Gear |
Using SST and a press, remove the rear output shaft bearing (inner race) and 6th driven gear from the output shaft.
Support the output shaft by hand to prevent it from dropping.
33431C
6.REMOVE OUTPUT GEAR SPACER (between 6th driven gear and 5th driven gear)
Remove the output gear spacer from the output shaft.
33422B
7.REMOVE 4TH DRIVEN GEAR
| *1 | 5th Driven Gear |
| *2 | 4th Driven Gear |
Using SST and a press, remove the 5th driven gear and 4th driven gear from the output shaft.
Support the output shaft by hand to prevent it from dropping.
33431C
8.REMOVE OUTPUT GEAR SPACER (between 4th driven gear and 3rd driven gear)
Remove the output gear spacer from the output shaft.
33332
9.REMOVE 2ND GEAR
| *1 | 3rd Driven Gear |
| *2 | 2nd Gear |
Using SST and a press, remove the 3rd driven gear and 2nd gear from the output shaft.
Do not tighten SST excessively.
Support the output shaft by hand to prevent it from dropping.
33356A
10.REMOVE INNER 2ND GEAR BEARING RACE
Remove the inner 2nd gear bearing race from the output shaft.
Using a Magnet Hand, remove the inner 2nd gear bearing race lock ball from the output shaft.
33037B
11.REMOVE NO. 1 SYNCHRONIZER RING SET (for 2nd Gear)
| *1 | No. 1 Synchronizer Ring Set (for 2nd Gear) |
| *a | Inner Ring |
| *b | Middle Ring |
| *c | Outer Ring |
Remove the No. 1 synchronizer ring set (for 2nd gear) from the No. 1 transmission clutch hub.
33361
12.REMOVE NO. 1 TRANSMISSION CLUTCH HUB
Remove the No. 1 transmission clutch hub together with the No. 1 transmission hub sleeve and 3 No. 1 synchromesh shifting keys from the output shaft.
Remove the No. 1 transmission hub sleeve and 3 No. 1 synchromesh shifting keys from the No. 1 transmission clutch hub.
33348
13.REMOVE 1ST GEAR THRUST WASHER
Remove the 1st gear thrust washer from the output shaft.
33037B
14.REMOVE NO. 1 SYNCHRONIZER RING SET (for 1st Gear)
| *1 | No. 1 Synchronizer Ring Set (for 1st Gear) |
| *a | Inner Ring |
| *b | Middle Ring |
| *c | Outer Ring |
Remove the No. 1 synchronizer ring set (for 1st gear) from the 1st gear.
33335
15.REMOVE 1ST GEAR
Remove the 1st gear together with the 1st gear needle roller bearing from the output shaft.
Remove the 1st gear needle roller bearing from the 1st gear.
33345
16.REMOVE 1ST GEAR BUSHING
Remove the 1st gear needle roller bearing from the 1st gear bushing.
Remove the 1st gear bushing from the output shaft.
33321N
17.REMOVE FRONT OUTPUT SHAFT BEARING (INNER RACE)
Using SST and a press, remove the front output shaft bearing (inner race) from the output shaft.
Do not tighten SST excessively.
Support the output shaft by hand to prevent it from dropping.