The skid control ECU (brake booster with master cylinder assembly) stores this DTC if malfunctions are found in the circuit inside the ECU by self diagnosis.
| DTC No. | Detection Item | INF Code | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|---|
| C1300 | Skid Control ECU Malfunction | ·
1001 to 1010 ·
1012 to 1030 |
Skid control ECU (Brake booster with master cylinder assembly) internal malfunction | Skid control ECU (Brake booster with master cylinder assembly) | - |
Replace the skid control ECU (brake booster with master cylinder assembly).
for LHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for LHD without Vacuum Brake Booster)>REMOVAL
for RHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for RHD without Vacuum Brake Booster)>REMOVAL
Perform initialization and calibration of the linear solenoid valve.
| Tester Display |
|---|
| ECB Utility |
Perform zero point calibration of the yaw rate and acceleration sensor.
| Tester Display |
|---|
| Test Mode |
Perform the sensor check in Test Mode Procedure.
| Tester Display |
|---|
| Signal Check |
| Proceed to |
|---|
| NEXT |
NEXT