Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/o Vacuum Brake Booster)
RM3620E _54 Brake _076410 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0379312 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(w/o Vacuum Brake Booster) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(w/o Vacuum Brake Booster)  C1440  Steering Angle Sensor Unusual Bank Angle Detected  


DESCRIPTION

If the skid control ECU (brake booster with master cylinder assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (brake booster with master cylinder assembly) stores DTC C1440 while VSC operation is temporarily disabled.

This is not a malfunction if the system and sensor circuits are normal and if normal VSC operation resumes.

DTC No. Detection Item INF Code DTC Detection Condition Trouble Area Note
C1440 Steering Angle Sensor Unusual Bank Angle Detected - Driving at a steep bank angle. Yaw rate and acceleration sensor (Airbag sensor assembly) -

PROCEDURE

1.CHECK DTC

b.

Turn the power switch off.


c.

Perform a road test.


d.

Check if the same DTC is output.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/o Vacuum Brake Booster)>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
DTC C1440 is output. A
DTC C1440 is not output. B
Yaw rate and acceleration sensor DTCs are output. C



A

2.CLEAR DTC

B

END

C

2.CLEAR DTC
a.

Clear the DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/o Vacuum Brake Booster)>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Clear DTCs
50002 105
HINT:
·

If the skid control ECU (brake booster with master cylinder assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (brake booster with master cylinder assembly) stores DTC C1440 while VSC operation is temporarily disabled.

·

This is not a malfunction if the system and sensor circuits are normal and if normal VSC operation resumes.




Result:
Proceed to
NEXT



NEXT

END