Home › Drivetrain › K120 (MULTIDRIVE / CVT) › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM
RM3620E _52 Drivetrain _076272 K120 MULTIDRIVE / CVT _0372181 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM T

K120 MULTIDRIVE / CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.

·

*1: w/ Shift Paddle Switch

·

*2:

If the engine stalls 3 times or more, the TCM suspects that the shift solenoid valve SLU is stuck on. In this case, the TCM releases the lock-up oil pressure when the engine is next started as engine stall avoidance control.

If the shift lever is moved to D or R during engine stall avoidance control, shift shock will occur. In this case, the variable gear ratio range and output torque will be restricted.

If the shift solenoid valve SLU is not malfunctioning, engine stall avoidance control can be canceled by performing either of the following procedures:

- Using the GTS, perform "Reset Memory". After performing "Reset Memory", make sure to perform "Deceleration Sensor Zero Point Calibration", and then "CVT Oil Pressure Calibration". After finishing, drive the vehicle to perform learning.

Click hereDrivetrain>K120 (MULTIDRIVE / CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION

- Drive the vehicle at 40 km/h (25 mph) or more for 5 seconds or more and then stop the vehicle.

If the vehicle is attempted to be stopped when the shift solenoid valve SLU is malfunctioning or when engine stall avoidance control has not been canceled, engine stall avoidance control will be performed to prevent another engine stall. In this case, shift shock will occur and the variable gear ratio range and output torque will be restricted.



Continuously Variable Transaxle System
Symptom Suspected Area Link
No gear change by moving shift lever to "+" or "-" from M Transmission control switch circuit Click here
No gear change by operating "+" or "-" shift paddle switch*1 Shift paddle switch circuit Click here
SPORT mode does not operate SPORT switch (Integration control and panel assembly) circuit Click here
Even though the shift lever is moved to any position, the shift position indicator does not change CAN communication system Click here
Perform Active Test (Combination Meter Assembly) Click here
Harsh engagement when shift mode is changed to gear mode Transaxle compensation code is not registered Click here
When the shift lever is moved to D or R from P or N, shift shock occurs and there is a lack of power. Engine stall avoidance control*2 -
Shift solenoid valve SLU (System malfunction) Click here
Shift solenoid valve SLU (Electrical malfunction) Click here
Shift solenoid valve SLP (System malfunction) Click here
Shift solenoid valve SLP (Electrical malfunction) Click here