Home › Drivetrain › GF2A (TRANSFER / 4WD / AWD) › DYNAMIC TORQUE VECTORING AWD SYSTEM
RM3620E _52 Drivetrain _077125 GF2A TRANSFER / 4WD / AWD _0379783 DYNAMIC TORQUE VECTORING AWD SYSTEM C

GF2A TRANSFER / 4WD / AWD  DYNAMIC TORQUE VECTORING AWD SYSTEM  C13F800  4WD/AWD Rear Disconnect System Performance  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory
C13F800 4WD/AWD Rear Disconnect System Performance
·

When it is determined twice that rotation synchronization is not possible when switching from disconnect to connect continuously for 7 seconds.

·

Any of the following conditions occur a total of 3 times consecutively.

-

The No. 2 4 wheel drive position switch does not indicate the engagement determination when switching from disconnect to connect continuously for 6 seconds.

-

The No. 2 4 wheel drive position switch does not indicate the release determination when switching from connect to disconnect continuously for 5 seconds.

-

The No. 2 4 wheel drive position switch changed state continues for 60 seconds when switching to the disconnect state or the connect state.



·

Rear 4WD linear solenoid (rear differential carrier assembly)

·

No. 2 4 wheel drive position switch


Displayed Yes

DTC Detection Conditions: C13F800
Vehicle Condition
Pattern 1 Pattern 2 Pattern 3 Pattern 4 Pattern 5
Diagnosis Condition When switching from disconnect to connect ○ ○ - - -
When switching from connect to disconnect - - ○ - -
Disconnect state - - - ○ -
Connect state - - - - ○
Malfunction Status Rotation synchronization is not possible continuously for 7 seconds ○ - - - -
The No. 2 4 wheel drive position switch does not indicate the engagement determination continuously for 6 seconds - ○ - - -
The No. 2 4 wheel drive position switch does not indicate the release determination continuously for 5 seconds - - ○ - -
The No. 2 4 wheel drive position switch changed state continuously for 60 seconds - - - ○ ○
Detection Time 2 times for pattern 1 Any malfunction status occurs a total of 3 times consecutively for patterns 2 to 5
Number of Trips -

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.


PROCEDURE

1.CHECK FOR DTC
a.

Check whether DTCs other than C13F800 are output.

Click hereDrivetrain>GF2A (TRANSFER / 4WD / AWD)>DYNAMIC TORQUE VECTORING AWD SYSTEM>DTC CHECK / CLEAR

Chassis > Four Wheel Drive > Trouble Codes
50001 448

Result:
Result Proceed to
Only DTC C13F800 is output. A
DTC C13F800 and C13E01C are output. B
DTC C13F800 and C13ED1C are output. C



A

B

C