The side collision sensor RH circuit consists of the airbag sensor assembly, side airbag pressure sensor RH and No. 2 side airbag sensor assembly RH.
The No. 2 side airbag sensor assembly RH detects impacts to the vehicle and send signals to the airbag sensor assembly to determine if the SRS should be deployed.
These DTCs are stored when a malfunction is detected in the No. 2 side airbag sensor assembly RH or airbag sensor assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Test Mode / Check Mode |
|---|---|---|---|---|---|
| B1630 | Curtain Shield Airbag Sensor (RH) | Either condition is met:
·
A No. 2 side airbag sensor assembly RH malfunction. ·
An airbag sensor assembly malfunction. |
·
No. 2 side airbag sensor assembly RH ·
Airbag sensor assembly |
Comes on | Not applicable |
| B1632 | Curtain Shield Airbag Sensor Lost Communication (RH) | Either condition is met:
·
A No. 2 side airbag sensor assembly RH malfunction. ·
An airbag sensor assembly malfunction. |
·
No. 2 side airbag sensor assembly RH ·
Airbag sensor assembly |
Comes on | Not applicable |
When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
After replacing the airbag sensor assembly, refer to initialization.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
| *1 | No. 2 Side Airbag Sensor Assembly LH |
| *2 | Airbag Sensor Assembly |
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Interchange the No. 2 side airbag sensor assembly RH with LH and connect the connectors to them.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the engine switch on (IG), and wait for at least 60 seconds.
Clear the DTCs stored in memory.
Turn the engine switch off.
Turn the engine switch on (IG), and wait for at least 60 seconds.
Check for DTCs.
| Proceed to |
|---|
| DTC B1630 or B1632 is output |
| DTC B1635 or B1637 is output |
| DTCs B1630, B1632, B1635 and B1637 are not output |
Codes other than DTC B1630, B1632, B1635 and B1637 may be output at this time, but they are not related to this check.
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Return the No. 2 side airbag sensor assembly LH and RH to their original positions and connect the connectors to them.
DTC B1630 or B1632 is output
DTC B1635 or B1637 is output
DTCs B1630, B1632, B1635 and B1637 are not output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING