Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION SYSTEM (for HV Model)
RM3620E _58 Vehicle Interior _076036 SUPPLEMENTAL RESTRAINT SYSTEMS _0379921 OCCUPANT CLASSIFICATION SYSTEM(for HV Model) C

SUPPLEMENTAL RESTRAINT SYSTEMS  OCCUPANT CLASSIFICATION SYSTEM(for HV Model)  B1798  Yaw Rate Sensor Module Malfunction  B1799  Vehicle Stability Control ECU Malfunction  


DESCRIPTION

The occupant detection ECU receives signals from the skid control ECU assembly via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1798 Yaw Rate Sensor Module Malfunction Acceleration signals are abnormal
·

Airbag Sensor Assembly

·

CAN communication system

·

Occupant detection ECU


B1799 Vehicle Stability Control ECU Malfunction Vehicle speed signal from brake booster with master cylinder assembly (skid control ECU) is abnormal
·

Electronically controlled brake system

·

CAN communication system

·

Occupant detection ECU



CAUTION / NOTICE / HINT

HINT:
·

When DTC B1650 is stored as a result of troubleshooting for the airbag system, check the DTCs stored in the occupant detection ECU. When DTC B1798 or B1799 is output, perform troubleshooting for this DTC first.

·

If it is difficult to perform troubleshooting (wire harness inspection), remove the front passenger seat installation bolts to see under the seat cushion.

·

In the above case, lift and hold the seat so that it does not fall down. Hold the seat only as necessary because holding the seat for a long period of time may cause seat rail deformation.



PROCEDURE

1.CHECK DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
a.

Check for electronically controlled brake system DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/o Vacuum Brake Booster)>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
OK:

DTCs are not output.



Result:
Proceed to
OK
NG



OK

2.CHECK CAN COMMUNICATION SYSTEM

NG

2.CHECK CAN COMMUNICATION SYSTEM
a.

Using the GTS, check if the CAN communication system is functioning normally.

HINT:

Refer to CAN Bus Check in CAN Communication System.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for HV Model)>DIAGNOSIS SYSTEM


OK:

CAN communication system is functioning normally.



Result:
Proceed to
OK
NG



OK

3.CHECK DTC (HEALTH CHECK)

NG

3.CHECK DTC (HEALTH CHECK)
a.

Turn the power switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG) and turn the GTS on.


d.

Enter the following menus: System Select / Health Check.

OK:

DTCs are not output.



Result:
Proceed to
OK
NG



OK

NG

GO TO OTHER DIAGNOSTIC TROUBLE CODE CHART