87130D
1.REMOVE BLOWER ASSEMBLY
87201B
2.REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY
88897P
3.REMOVE ASPIRATOR
88625Q
4.REMOVE COOLER THERMISTOR (ROOM TEMPERATURE SENSOR)
88539J
5.REMOVE DRAIN COOLER HOSE
82210K
6.REMOVE AIR CONDITIONING HARNESS ASSEMBLY
Disconnect each connector.
| *a | Clamp | *b | Guide |
Detach the clamp and guide and remove the air conditioning harness assembly.
87050C
7.REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
87050D
8.REMOVE NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
Remove the 2 screws.
Detach the guide and remove the No. 2 air conditioning radiator damper servo sub-assembly.
88897M
9.REMOVE HEATER PIPE GROMMET
87124B
10.REMOVE HEATER CLAMP
87107A
11.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
88899L
12.REMOVE COOLING UNIT PARTS
Remove the cooling unit parts.
88515
13.REMOVE COOLER EXPANSION VALVE
Using a 4 mm hexagon socket wrench, remove the 2 hexagon bolts and cooler expansion valve.
Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
88501
14.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
Remove the 2 screws.
| *a | No. 1 Cooler Thermistor Lead Wire | - | - |
|
Detach lead wire from guide | - | - |
Detach the claw and guide, and then while detaching the lead wire of the No. 1 cooler thermistor from the guide, separate the upper heater case with No. 1 cooler evaporator sub-assembly from the lower heater case as shown in the illustration.
Detach the guide.
Remove the No. 1 cooler evaporator sub-assembly with No. 1 cooler thermistor from the upper heater case.
88625
15.REMOVE NO. 1 COOLER THERMISTOR
87114B
16.REMOVE HEATER COVER