Use the same procedure as for the LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
for HFC-134a (R134a):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT (for HFC-134a(R134a))>REPLACEMENT
for HFO-1234yf (R1234yf):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT (for HFO-1234yf(R1234yf))>REPLACEMENT
88719A
2.REMOVE AIR CONDITIONER PRESSURE SENSOR
Disconnect the connector.
| *A | for A25A-FXS | *B | for A25A-FKS |
| *C | for A25B-FXS | *D | for M20A-FKS |
| *E | w/o Sub-cool Accelerator | *F | w/ Sub-cool Accelerator |
Using a 27 mm deep socket wrench, remove the air conditioner pressure sensor as shown in the illustration.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
| *A | for A25A-FXS | *B | for A25A-FKS |
| *C | for A25B-FXS | *D | for M20A-FKS |
| *E | w/o Sub-cool Accelerator | *F | w/ Sub-cool Accelerator |
| *a | Hold | *b | Turn |
|
Remove in this Direction | - | - |