Home › General › MAINTENANCE › A25B-FXS AUXILIARY BATTERY › 2019.02–2020.08
RM3620E _V1 General _076298 MAINTENANCE _0389009 A25B-FXS AUXILIARY BATTERY A

MAINTENANCE  A25B-FXS AUXILIARY BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during auxiliary battery removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for HV model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for HV model) (Click here)
Reset back door close position Power back door system (for HV model) (Click here)
Power back door initialization Power door lock control system (Click here)

NOTICE:

After the power switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the power switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

w/ Canister Pump Module:

When replacing the battery, use a new battery of the same dimensions with a capacity of 55 Ah or more at a 20-hour rate.

·

w/o Canister Pump Module:

When replacing the battery, use a new battery of the same dimensions with a capacity of 45 Ah or more at a 20-hour rate.



Hide 58410B 2.REMOVE DECK BOARD ASSEMBLY

a.
B515128

Remove the deck board assembly.


Hide 58416K 3.REMOVE REAR NO. 2 FLOOR BOARD

a.
B515134

Detach the 2 clips and 2 guides and remove the rear No. 2 floor board.


Hide 65351A 4.REMOVE BATTERY HOLE COVER

A432067

a.

Detach the 12 claws and remove the battery hole cover.


Hide 5.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

a.
A432042

Loosen the nut, and disconnect the cable from the negative (-) auxiliary battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



Hide 6.REMOVE AUXILIARY BATTERY

a.
A432043

Detach the 2 claws and open the connector cover.


b.
A432044

Loosen the nut and disconnect the cable from the positive (+) auxiliary battery terminal.


c.
A432045

Disconnect the battery hose from the auxiliary battery.


d.
A432048

Remove the bolt, nut and battery clamp sub-assembly as shown in the illustration.


e.
A432050

Remove the battery insulator.


f.

Remove the auxiliary battery.


g.
A432066

w/ No. 1 Battery Spacer:

Remove the No. 1 battery spacer.