The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during throttle body with motor assembly removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1.DRAIN ENGINE COOLANT
12601B
2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
17750A
3.REMOVE INLET AIR CLEANER ASSEMBLY
Remove the 2 bolts and inlet air cleaner assembly.
4.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
Disconnect the mass air flow meter sub-assembly connector.
Detach the wire harness clamp.
| *a | Grommet |
| *b | Pin |
Slide the clip and disconnect the No. 2 PCV hose from the cylinder head cover sub-assembly.
Loosen the hose clamp and disconnect the air cleaner hose from the throttle body with motor assembly.
Detach the 2 grommets and pin to remove the air cleaner assembly with air cleaner hose.
22030
5.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
Disconnect the throttle body with motor assembly connector.
Slide the clip and disconnect the No. 5 water by-pass hose from the throttle body with motor assembly.
Remove the 3 bolts and disconnect the throttle body with motor assembly from the intake manifold.
Slide the clip and disconnect the No. 6 water by-pass hose to remove the throttle body with motor assembly.
If the throttle body with motor assembly has been struck or dropped, replace it.
Remove the throttle body gasket from the intake manifold.