Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for ERA-GLONASS) › 2019.02–2019.09
RM3620E _56 Audio / Visual / Telematics _076049 TELEMATICS _0389152 TELEMATICS SYSTEM(for ERA-GLONASS) C

TELEMATICS  TELEMATICS SYSTEM(for ERA-GLONASS)  B1572  Microphone Error  


DESCRIPTION

This DTC is stored when a microphone signal line is disconnected.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1572 Microphone Error Current at terminal MCVD exceeds the malfunction threshold for 10 seconds or more while the power switch is on (IG).
·

Telephone transceiver assembly

·

Map light assembly (telephone microphone assembly)

·

Map light assembly

·

Harness or connector



WIRING DIAGRAM

E384839E11
0.729,0.854 1.26,1.063 0.531,0.208 10 false MACC 0.813,1.323 1.271,1.531 0.458,0.208 10 false MIC+ 0.823,1.802 1.281,2.01 0.458,0.208 10 false MIC- 0.302,2.229 1.708,2.604 1.406,0.375 10 false A 1.313,0.76 1.469,0.958 0.156,0.198 10 false 5 1.313,1.24 1.469,1.438 0.156,0.198 10 false 3 1.313,1.708 1.469,1.906 0.156,0.198 10 false 2 2.063,0.75 2.219,0.948 0.156,0.198 10 false 7 2.073,1.219 2.229,1.417 0.156,0.198 10 false 6 2.073,1.708 2.229,1.906 0.156,0.198 10 false 5 1.521,0.76 2.052,0.969 0.531,0.208 10 false MACC 1.531,1.25 2.063,1.458 0.531,0.208 10 false MCO+ 1.542,1.719 2.073,1.927 0.531,0.208 10 false MCO- 0.396,3.146 0.896,3.417 0.5,0.271 10 false P14 0.406,3.313 2.167,3.656 1.76,0.344 10 false Map Light Assembly 5.604,0.76 5.844,0.958 0.24,0.198 10 false 33 5.615,1.24 5.854,1.438 0.24,0.198 10 false 34 5.615,1.719 5.854,1.917 0.24,0.198 10 false 35 5.615,2.292 5.854,2.49 0.24,0.198 10 false 32 5.938,0.833 6.469,1.042 0.531,0.208 10 false MCVD 5.917,1.323 6.448,1.531 0.531,0.208 10 false MCI+ 5.927,2.385 6.458,2.594 0.531,0.208 10 false SGND 5.917,1.792 6.448,2 0.531,0.208 10 false MCI- 5.521,2.76 5.823,2.948 0.302,0.188 10 false H6 5.51,2.927 6.885,3.563 1.375,0.635 10 false Telephone Transceiver Assembly 3.781,2.323 3.938,2.49 0.156,0.167 10 false * 2.49,3.344 3.552,3.573 1.063,0.229 10 false *: Shielded 0.302,2.385 1.708,2.76 1.406,0.375 10 false Telephone Microphone Assembly

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>REGISTRATION

·

When replacing the telephone transceiver assembly, make sure to replace it with a new one.



PROCEDURE

1.CHECK DTC
a.

Turn the power switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG) and wait for 20 seconds.


d.

Turn the GTS on.


e.

Check for DTCs and check that no DTCs are output.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>DTC CHECK / CLEAR

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

2.CHECK HARNESS AND CONNECTOR (TELEPHONE TRANSCEIVER ASSEMBLY - MAP LIGHT ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY))
2.CHECK HARNESS AND CONNECTOR (TELEPHONE TRANSCEIVER ASSEMBLY - MAP LIGHT ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY))
a.

Disconnect the H6 telephone transceiver assembly connector.


b.

Disconnect the P14 map light assembly (telephone microphone assembly) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H6-33 (MCVD) - P14-7 (MACC) Always Below 1 Ω
H6-34 (MCI+) - P14-6 (MCO+) Always Below 1 Ω
H6-35 (MCI-) - P14-5 (MCO-) Always Below 1 Ω
H6-33 (MCVD) or P14-7 (MACC) - Body ground Always 10 kΩ or higher
H6-34 (MCI+) or P14-6 (MCO+) - Body ground Always 10 kΩ or higher
H6-35 (MCI-) or P14-5 (MCO-) - Body ground Always 10 kΩ or higher
H6-32 (SGND) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.INSPECT MAP LIGHT ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT MAP LIGHT ASSEMBLY
a.

Remove the map light assembly.

Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL


b.

Remove the telephone microphone assembly.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEPHONE MICROPHONE ASSEMBLY>REMOVAL


c.
E405964C05
0.094,0.854 0.479,1.135 0.385,0.281 0.344,2.396 0.729,2.677 0.385,0.281 1.448,0.948 1.208,0.188 1.208,0.188 1.385,0.188 true 1.635,0.948 1.99,0.208 1.99,0.208 2.167,0.208 true 2.271,2.792 2.417,3.01 2.417,3.01 2.573,3.01 true 1.76,2.771 2.125,3.198 2.125,3.198 2.302,3.198 true 1.802,0.948 2.688,0.427 2.688,0.427 2.865,0.427 true 1.448,2.781 1.521,3.24 1.521,3.24 1.698,3.24 true 0.156,0.115 0.469,0.313 0.313,0.198 10 false *a 0.167,0.917 0.677,1.24 0.51,0.323 10 false P14 0.49,2.458 0.698,2.677 0.208,0.219 10 false A 2.615,2.927 3.052,3.135 0.438,0.208 10 false MACC 1.438,0.125 1.875,0.333 0.438,0.208 10 false MACC 2.198,0.125 2.677,0.344 0.479,0.219 10 false MCO+ 2.896,0.365 3.375,0.583 0.479,0.219 10 false MCO- 2.344,3.115 2.823,3.333 0.479,0.219 10 false MIC+ 1.76,3.156 2.24,3.375 0.479,0.219 10 false MIC-
*a Component without harness connected
(Map Light Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
P14-7 (MACC) - A-5 (MACC) Always Below 1 Ω
P14-6 (MCO+) - A-3 (MIC+) Always Below 1 Ω
P14-5 (MCO-) - A-2 (MIC-) Always Below 1 Ω
P14-7 (MACC) - P14-6 (MCO+) Always 10 kΩ or higher
P14-7 (MACC) - P14-5 (MCO-) Always 10 kΩ or higher
P14-6 (MCO+) - P14-5 (MCO-) Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.CHECK TELEPHONE MICROPHONE ASSEMBLY

NG

REPLACE MAP LIGHT ASSEMBLY

4.CHECK TELEPHONE MICROPHONE ASSEMBLY
a.

Replace the telephone microphone assembly with a new or known good one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEPHONE MICROPHONE ASSEMBLY>REMOVAL


b.

Clear the DTCs.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>DTC CHECK / CLEAR

Body Electrical > Telematics > Clear DTCs
50002 233

c.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END (TELEPHONE MICROPHONE ASSEMBLY IS DEFECTIVE)

NG

5.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
5.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
a.

Replace the telephone transceiver assembly with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL


Result:
Proceed to
NEXT



NEXT