The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during PCV valve (ventilation valve sub-assembly) removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
17111
1.REMOVE INTAKE MANIFOLD
12204C
2.REMOVE PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY)
Remove the PCV valve (ventilation valve sub-assembly) from the cylinder head sub-assembly.