Home › General › MAINTENANCE › A25B-FXS SPARK PLUG › from 2019.02
RM3620E _V1 General _076298 MAINTENANCE _0389006 A25B-FXS SPARK PLUG A

MAINTENANCE  A25B-FXS SPARK PLUG  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during spark plug removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of ignition coil assembly

·

Replacement of spark plug


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 19100P 3.REMOVE SPARK PLUG

a.

Remove the 4 spark plugs from the cylinder head sub-assembly.

NOTICE:

If a spark plug has been struck or dropped, replace it.