Home › Engine / Hybrid System › A25B-FXS (COOLING) › WATER PUMP › from 2019.02
RM3620E _51 Engine / Hybrid System _080121 A25B-FXS COOLING _0389723 WATER PUMP A

A25B-FXS COOLING  WATER PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine water pump assembly (water inlet housing) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of throttle body with motor assembly

·

Replacement of EGR valve assembly

·

Gas leaks from exhaust system


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:
·

After the power switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the power switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.

·

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



PROCEDURE

Hide 16031 1.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

Hide 16032 2.REMOVE ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)

a.
A434817

Disconnect the sensor wire connector.


b.
A434818

Using an 8 mm socket wrench, remove the bolt and disconnect the sensor wire from the engine water pump assembly (water inlet housing).


c.
A434819

Disconnect the engine water pump assembly (water inlet housing) connector.


d.
A434820

Remove the 4 bolts and engine water pump assembly (water inlet housing) from the cylinder block assembly.


e.
A402026

Remove the gasket from the engine water pump assembly (water inlet housing).