Home › Engine / Hybrid System › A25B-FXS (COOLING) › THERMOSTAT › from 2019.02
RM3620E _51 Engine / Hybrid System _080121 A25B-FXS COOLING _0389724 THERMOSTAT A

A25B-FXS COOLING  THERMOSTAT  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during water inlet with thermostat sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Link
·

Replacement of throttle body with motor assembly

·

Replacement of EGR valve assembly

·

Gas leaks from exhaust system


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:
·

After the power switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the power switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.

·

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



PROCEDURE

Hide 1.DRAIN ENGINE COOLANT (for Engine)

Hide 16572D 3.DISCONNECT NO. 2 RADIATOR HOSE

Hide 16031 4.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

a.
A434823

Disconnect the water inlet with thermostat sub-assembly connector.


b.
A434824

Slide the clip and disconnect the No. 7 water by-pass hose from the water inlet with thermostat sub-assembly.

NOTICE:
·

Do not apply force to the water inlet with thermostat sub-assembly when disconnecting the No. 7 water by-pass hose.

·

Do not damage the water inlet with thermostat sub-assembly.



HINT:

When disconnecting the No. 7 water by-pass hose, slide the clip, rotate the hose and pull it straight off the pipe.



c.
A434825

Using an 8 mm socket wrench, remove the 2 bolts and water inlet with thermostat sub-assembly.


d.
A402018

Remove the gasket from the water inlet with thermostat sub-assembly.