The motor generator control ECU, which is built into the inverter with converter assembly, monitors its internal operation and will store DTCs if it detects a malfunction.
If any of the following DTCs are output, replace the inverter with converter assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate |
|---|---|---|---|---|---|
| P1C2C1C | Drive Motor "B" Control Module AD Converter Circuit Voltage Out of Range | Motor generator control ECU internal malfunction
(1 trip detection logic) |
Inverter with converter assembly | Comes on | Master Warning:
Comes on |
| P1C2C49 | Drive Motor "B" Control Module AD Converter Circuit Internal Electronic Failure | Motor generator control ECU internal malfunction
(1 trip detection logic) |
Inverter with converter assembly | Comes on | Master Warning:
Comes on |
| P1C631F | Drive Motor "B" Control Module Offset Power Circuit Intermittent | Motor generator control ECU internal malfunction detected when DTC P0C7917, P0D3319, P1C5D19, P1C5F19 or P1C5E19 is stored.
(1 trip detection logic) |
Inverter with converter assembly | Does not come on | Master Warning:
Does not come on |
| P262C1C | Drive Motor "B" Control Module Offset Power Circuit Voltage Out of Range | Motor generator control ECU internal malfunction
(1 trip detection logic) |
Inverter with converter assembly | Comes on | Master Warning:
Comes on |
| P310B1F | Communication Error from Drive Motor "A" to Drive Motor "B" Circuit Intermittent | Communication error (circuit intermittent from motor to rear motor) detected when DTC P0C7917, P0D3319, P1C5D19, P1C5F19 or P1C5E19 is stored.
(1 trip detection logic) |
Inverter with converter assembly | Does not come on | Master Warning:
Does not come on |
| P310B83 | Communication Error from Drive Motor "A" to Drive Motor "B" Value of Signal Protection Calculation Incorrect | Motor generator control ECU internal malfunction
(1 trip detection logic) |
Inverter with converter assembly | Comes on | Master Warning:
Comes on |
| P310B86 | Communication Error from Drive Motor "A" to Drive Motor "B" Signal (Some Circuit Quantity, Reported via Serial Data) Invalid | Motor generator control ECU internal malfunction
(1 trip detection logic) |
Inverter with converter assembly | Comes on | Master Warning:
Comes on |
| P310B87 | Communication Error from Drive Motor "A" to Drive Motor "B" Missing Message | Motor generator control ECU internal malfunction
(1 trip detection logic) |
Inverter with converter assembly | Comes on | Master Warning:
Comes on |
| P32CF1F | Lost Communication between Drive Motor "A" and "B" (Drive Motor "B") Circuit Intermittent | Communication error (circuit intermittent from generator to rear motor) detected when DTC P0C7917, P0D3319, P1C5D19, P1C5F19 or P1C5E19 is stored.
(1 trip detection logic) |
Inverter with converter assembly | Does not come on | Master Warning:
Does not come on |
| P32CF83 | Lost Communication between Drive Motor "A" and "B" (Drive Motor "B") Value of Signal Protection Calculation Incorrect | Motor generator control ECU internal malfunction
(1 trip detection logic) |
Inverter with converter assembly | Comes on | Master Warning:
Comes on |
| P32CF86 | Lost Communication between Drive Motor "A" and "B" (Drive Motor "B") Signal (Some Circuit Quantity, Reported via Serial Data) Invalid | Motor generator control ECU internal malfunction
(1 trip detection logic) |
Inverter with converter assembly | Comes on | Master Warning:
Comes on |
| P32CF87 | Lost Communication between Drive Motor "A" and "B" (Drive Motor "B") Missing Message | Motor generator control ECU internal malfunction
(1 trip detection logic) |
Inverter with converter assembly | Comes on | Master Warning:
Comes on |
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Connect the GTS to the DLC3.
Turn the power switch on (IG) and turn the GTS on.
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the power switch off and wait for 2 minutes or more.
Turn the power switch on (IG) and turn the GTS on.
With power switch on (IG) and wait for 15 seconds or more.
Enter the following menus: Powertrain / Rear Motor Generator / Utility / All Readiness.
Check the DTC judgment result.
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE, perform driving pattern again.
Go to Motor Generator Control System.
For the P1C2C1C, P1C2C49, P1C631F, P262C1C, P310B1F, P310B83, P310B86, P310B87, P32CF1F, P32CF83, P32CF86 and P32CF87 inspection procedures, refer to the Motor Generator Control System section.
| Result |
|---|
| NEXT |
NEXT