Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for ERA-GLONASS) › from 2019.09
RM3620E _56 Audio / Visual / Telematics _076049 TELEMATICS _0389152 TELEMATICS SYSTEM(for ERA-GLONASS) C

TELEMATICS  TELEMATICS SYSTEM(for ERA-GLONASS)  B1570  Red LED Error  


DESCRIPTION

This DTC is stored when the telephone transceiver assembly detects an open or short in the manual (SOS) switch indicator (red) circuit of the manual (SOS) switch.

The manual (SOS) switch indicator (red) illuminates for 10 seconds and turns off when the ignition switch is turned to ON.

If a malfunction in the telematics system is detected, the manual (SOS) switch indicator (red) will illuminate. However, the manual (SOS) switch indicator (red) may not illuminate when this DTC is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1570 Red LED Error Current for the manual (SOS) switch indicator (red) exceeds malfunction threshold for 10 seconds or more when the ignition switch is ON.
·

Telephone transceiver assembly

·

Map light assembly (manual (SOS) switch)

·

Harness or connector



WIRING DIAGRAM

E353337E21
4.781,1.74 5.396,1.938 0.615,0.198 10 false H6 1.031,2.135 1.646,2.333 0.615,0.198 10 false P14 1.052,2.302 3.563,2.771 2.51,0.469 10 false Map Light Assembly 1.51,1.74 2.906,1.938 1.396,0.198 10 false Manual (SOS) Switch 1.896,1.021 2.26,1.24 0.365,0.219 10 false RED 3.458,0.677 3.823,0.896 0.365,0.219 10 false IND1 3.396,1.094 3.813,1.302 0.417,0.208 10 false GND3 3.854,0.688 4.219,0.906 0.365,0.219 10 false 8 3.865,1.104 4.229,1.323 0.365,0.219 10 false 12 4.771,1.958 6.896,2.625 2.125,0.667 10 false Telephone Transceiver Assembly 5.167,1.094 5.531,1.313 0.365,0.219 10 false SIG- 5.156,0.771 5.521,0.99 0.365,0.219 10 false IND1 4.896,0.688 5.26,0.906 0.365,0.219 10 false 11 4.906,1.104 5.271,1.323 0.365,0.219 10 false 26

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>REGISTRATION

·

When replacing the telephone transceiver assembly, make sure to replace it with a new one.



HINT:

If DTC B1570 is stored, the manual (SOS) switch indicator (red) may not illuminate when another DTC is stored.


PROCEDURE

1.CHECK DTC
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON and wait for 20 seconds.


d.

Turn the GTS on.


e.

Check for DTCs and check that no DTCs are output.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>DTC CHECK / CLEAR

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

2.INSPECT MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH) (RED INDICATOR)
2.INSPECT MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH) (RED INDICATOR)
a.
B129570C46
1.615,1.813 1.24,1.094 true 2.594,1.76 2.427,1.333 true 0.073,0.094 0.354,0.333 0.281,0.24 10 false *a 2.625,1.75 3.146,1.969 0.521,0.219 10 false GND3 1.656,1.75 2.094,1.958 0.438,0.208 10 false IND1
*a Component without harness connected
(Map Light Assembly (Manual (SOS) Switch))


Remove the map light assembly (manual (SOS) switch).

Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL


b.

Connect 2 dry-cell batteries (1.5 V each) in series.


c.

Connect a positive (+) lead from the batteries to terminal 8 (IND1) and a negative (-) lead to terminal 12 (GND3) of the map light assembly (manual (SOS) switch) connector.


d.

Check if the manual (SOS) switch indicator (red) illuminates.

OK:

Manual (SOS) switch indicator (red) illuminates.



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (TELEPHONE TRANSCEIVER ASSEMBLY - MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH))

NG

REPLACE MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH)

3.CHECK HARNESS AND CONNECTOR (TELEPHONE TRANSCEIVER ASSEMBLY - MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH))
a.

Disconnect the H6 telephone transceiver assembly assembly.


b.

Disconnect the P14 map light assembly (manual (SOS) switch) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H6-11 (IND1) - P14-8 (IND1) Always Below 1 Ω
H6-11 (IND1) or P14-8 (IND1) - Body ground Always 10 kΩ or higher
H6-26 (SIG-) - P14-12 (GND3) Always Below 1 Ω
H6-26 (SIG-) or P14-12 (GND3) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
a.

Replace the telephone transceiver assembly with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL


Result:
Proceed to
NEXT



NEXT