The battery ECU assembly monitors its internal operation, it will set DTCs and perform fail-safe control when it detects the following malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate |
|---|---|---|---|---|---|
| P31B400 | Extreme Hybrid/EV Battery Charging Current | An abnormal signal is detected by the battery ECU assembly (excessive charging current).
(1 trip detection logic) |
Hybrid vehicle control ECU assembly | Does not come on | Master Warning:
Comes on |
| DTC No. | Data List |
|---|---|
| P31B400 | Hybrid/EV Battery Current |
After repairs have been completed, clear the DTCs and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Connect the GTS to the DLC3.
Turn the power switch on (IG) and turn the GTS on.
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the power switch off and wait for 2 minutes or more.
Turn the power switch on (IG) and turn the GTS on.
Drive the vehicle for approximately 10 minutes according to the freeze frame data items "Vehicle Speed", "Accelerator Position", "Hybrid/EV Battery Temperature 1 to 6" and "Hybrid/EV Battery Current".
Enter the following menus: Powertrain / HV battery / Utility / All Readiness.
Check the DTC judgment result.
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE, perform driving pattern again.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / HV Battery and Hybrid Control / Trouble Codes.
Check for DTCs.
| Result | Proceed to |
|---|---|
| "P31B400" only is output. | A |
| DTCs except "P31B400" of hybrid battery system are output. | B |
| DTCs except "P31B400" of hybrid control system are output. | C |
Turn the power switch off.
A
B
C
for 4WD/AWD:
for 2WD: