Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/o Vacuum Brake Booster) › from 2020.05
RM3620E _54 Brake _076410 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0379312 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(w/o Vacuum Brake Booster) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(w/o Vacuum Brake Booster)  C1259  HV Control System Regenerative Malfunction  C1310  HV System Malfunction  


DESCRIPTION

The skid control ECU (brake booster with master cylinder assembly) communicates with the hybrid vehicle control ECU assembly and controls braking force according to the motor's regenerative force.

The skid control ECU (brake booster with master cylinder assembly) sends VSC (cooperative control with EPS) signals to the hybrid vehicle control ECU assembly and receives operating signals from the hybrid vehicle control ECU assembly.

The skid control ECU (brake booster with master cylinder assembly) uses CAN communication for communicating with the hybrid vehicle control ECU assembly. If a communication malfunction is detected, the skid control ECU (brake booster with master cylinder assembly) prohibits VSC operation, brake hold operation and part of the electronically controlled brake system control as a fail-safe function.

If the signals from the hybrid vehicle control ECU assembly return to normal, the warning light will go off and the DTCs C1259 and C1310 will be cleared.

HINT:

These DTCs will be output from the skid control ECU (brake booster with master cylinder assembly) when the hybrid vehicle control ECU assembly sends a malfunction signal to the skid control ECU (brake booster with master cylinder assembly).


DTC No. Detection Item INF Code DTC Detection Condition Trouble Area Note
C1259 HV Control System Regenerative Malfunction - A regeneration malfunction signal is input for at least 0.036 seconds when IG2 terminal voltage is 9.5 V higher than for at least 2 seconds and communication with the hybrid vehicle control ECU assembly is valid. Hybrid vehicle control ECU assembly (Regeneration malfunction) -
C1310 HV System Malfunction 431
-
·

INF Code: 431

-

The hybrid control malfunction signal is received for at least 0.072 seconds from hybrid vehicle control ECU assembly.


·

INF Code: -

-

An internal malfunction signal is input for at least 0.072 seconds when IG2 terminal voltage is 9.5 V higher than for at least 2 seconds and communication with the hybrid vehicle control ECU assembly is valid.



·

INF Code: 431

-

Hybrid control system (Brake hold control malfunction)


·

INF Code: -

-

Hybrid vehicle control ECU assembly (VSC control malfunction)



-

PROCEDURE

1.CHECK HYBRID CONTROL SYSTEM

Result:
Result Proceed to
DTCs are not output. A
DTCs are output B



A

REPLACE HYBRID VEHICLE CONTROL ECU ASSEMBLY

B