11401L
1.INSTALL REAR ENGINE OIL SEAL
Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat level surface.
Using height adjustment attachments and plate lift attachments, keep the engine assembly level.
To prevent the No. 2 oil pan sub-assembly from deforming, do not place any attachments under the No. 2 oil pan sub-assembly of the engine assembly.
Using an engine sling device and engine lift, secure the engine assembly before servicing.
Apply MP grease to the lip of a new rear engine oil seal.
Keep the lip free from foreign matter.
Do not allow MP grease to contact the dust seal.
| *a | -0.9 to 1.1 mm |
Using SST and a hammer, tap in the rear engine oil seal.
-0.9 to 1.1 mm (-0.0354 to 0.0433 in.) (From the edge of the cylinder block sub-assembly and stiffening crankcase assembly)
Do not tap in the rear engine oil seal at an angle.
19315
2.INSTALL NO. 1 CRANKSHAFT POSITION SENSOR PLATE
Install the No. 1 crankshaft position sensor plate.
Align the pin hole of the No. 1 crankshaft position sensor plate with the pin of the crankshaft.
13405
3.INSTALL FLYWHEEL SUB-ASSEMBLY
Using SST, hold the crankshaft pulley assembly.
Clean the bolt holes.
| *a | Adhesive |
Apply adhesive to 2 or 3 threads at the end of each of the 8 new bolts.
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Install the flywheel sub-assembly with the 8 new bolts. Uniformly tighten the 8 new bolts in the sequence shown in the illustration.
Do not start the engine for at least 1 hour after installing the flywheel sub-assembly.
31270
4.INSTALL TRANSMISSION INPUT DAMPER ASSEMBLY
Using SST, hold the crankshaft pulley assembly.
Install the transmission input damper assembly to the flywheel sub-assembly with the 6 bolts. Uniformly tighten the 6 bolts in the order shown in the illustration.
Make sure that there are no oil on the transmission input damper assembly and flywheel sub-assembly.
Make sure to install the transmission input damper assembly in the correct direction.
Do not allow grease to contact the splines of the transmission input damper assembly and the input shaft.
30900
5.INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY