The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during auxiliary battery removal/installation are shown below.
After the power switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the power switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
w/ Canister Pump Module:
When replacing the battery, use a new battery of the same dimensions with a capacity of 55 Ah or more at a 20-hour rate.
w/o Canister Pump Module:
When replacing the battery, use a new battery of the same dimensions with a capacity of 45 Ah or more at a 20-hour rate.
58410B
2.REMOVE DECK BOARD ASSEMBLY
Remove the deck board assembly.
58416K
3.REMOVE REAR NO. 2 FLOOR BOARD
Detach the 2 clips and 2 guides and remove the rear No. 2 floor board.
65351A
4.REMOVE BATTERY HOLE COVER
Detach the 12 claws and remove the battery hole cover.
5.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Loosen the nut, and disconnect the cable from the negative (-) auxiliary battery terminal.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
6.REMOVE AUXILIARY BATTERY
Open the connector cover.
Loosen the nut and disconnect the cable from the positive (+) auxiliary battery terminal.
Disconnect the battery hose from the auxiliary battery.
Remove the bolt, nut and battery clamp sub-assembly as shown in the illustration.
Remove the auxiliary battery.
w/ No. 1 Battery Spacer:
Remove the No. 1 battery spacer.