Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL › from 2020.08
RM3620E _52 Drivetrain _076176 AXLE AND DIFFERENTIAL _0373316 REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL  REPLACEMENT  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear drive shaft oil seal LH removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear wheel alignment adjustment
·

Perform reset memory

·

Perform acceleration sensor zero point calibration and store system information memorization.


·

VSC is disabled or malfunctions

·

DTCs are output

·

Slip indicator light illuminates

·

ABS warning light illuminates


(Click here)
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement.)
·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (for Gasoline model) (Click here)
Television camera assembly optical axis (Back camera position setting) Parking Assist Monitor System (Click here)
·

Parking assist ECU initialization

·

Adjust steering angle


Panoramic View Monitor System (for Gasoline model) (Click here)
Perform headlight ECU sub-assembly LH initialization Lighting System (EXT) (Click here)

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 42340B 1.REMOVE REAR DRIVE SHAFT ASSEMBLY LH

Hide 42340D 2.REMOVE REAR DRIVE SHAFT OIL SEAL LH

a.
C403129N01
1.552,2.438 1.635,2.688 1.635,2.688 1.802,2.688 true 1.854,2.625 2.271,2.875 0.417,0.25 10 true SST

Using SST, tap out the rear drive shaft oil seal LH.

SST
09308-00010  

NOTICE:

Be careful not to damage the rear differential carrier sub-assembly.



Hide 42340D 3.INSTALL REAR DRIVE SHAFT OIL SEAL LH

a.

Coat the lip of a new rear drive shaft oil seal LH with MP grease.


b.
C403130C01
1.635,2.042 1.885,1.708 1.885,1.708 2.219,1.708 true 1.365,0.208 1.781,0.458 0.417,0.25 10 false *a 2.271,1.625 2.688,1.875 0.417,0.25 10 true SST
*a Depth


Using SST and a hammer, install the rear drive shaft oil seal LH to the rear differential carrier sub-assembly.

SST
09223-00010  

Standard Depth:

6.7 to 7.7 mm (0.264 to 0.303 in.)


NOTICE:
·

Tap the oil seal uniformly so that the oil seal is straight.

·

Do not tap the oil seal in too far.




Hide 42340B 4.INSTALL REAR DRIVE SHAFT ASSEMBLY LH