Home › Engine / Hybrid System › A25B-FXS (ENGINE CONTROL) › CAMSHAFT TIMING CONTROL MOTOR › from 2020.08
RM3620E _51 Engine / Hybrid System _080116 A25B-FXS ENGINE CONTROL _0389136 CAMSHAFT TIMING CONTROL MOTOR A

A25B-FXS ENGINE CONTROL  CAMSHAFT TIMING CONTROL MOTOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during cam timing control motor with EDU assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for HV model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for HV model) (Click here)
Reset back door close position Power back door system (for HV model) (Click here)
Power back door initialization Power door lock control system (Click here)
·

Cam timing control motor with EDU assembly

·

Removal and installation of a cam timing control motor with EDU assembly


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

·

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



PROCEDURE

Hide 58410B 1.REMOVE DECK BOARD ASSEMBLY

Hide 58416K 2.REMOVE REAR NO. 2 FLOOR BOARD

Hide 65351A 3.REMOVE BATTERY HOLE COVER

Hide 4.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 12601B 5.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 13090D 6.REMOVE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY

a.
A402348

Disconnect the cam timing control motor with EDU assembly connector.


b.

Remove the 3 bolts and cam timing control motor with EDU assembly from the No. 2 timing chain cover assembly.

NOTICE:

If the cam timing control motor with EDU assembly has been struck or dropped, replace it.



c.
A402350

Remove the cam timing control motor O-ring from the No. 2 timing chain cover assembly.