Home › Engine / Hybrid System › A25A-FXS (EMISSION CONTROL) › EGR COOLER › from 2020.08
RM3620E _51 Engine / Hybrid System _076503 A25A-FXS EMISSION CONTROL _0372417 EGR COOLER A

A25A-FXS EMISSION CONTROL  EGR COOLER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR cooler assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for HV model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Reset back door close position Parking support brake system (Click here)
Power back door initialization Power door lock control system (Click here)
Replacement of inverter with converter assembly Resolver learning
·

DTCs are stored

·

Slight vibration at a vehicle speed of 5 km/h (3 mph) or less

·

Shock or vibration during acceleration


(Click here)
Replacement of ECM Vehicle Identification Number (VIN) or frame number registration DTC P063051 is output w/ Canister Pump Module:
(Click here)
w/o Canister Pump Module:
(Click here)
Grille shutter switch specification infomation Vehicle control history (RoB) [X260E] is stored w/ Canister Pump Module:
(Click here)
w/o Canister Pump Module:
(Click here)
Gas leak from exhaust system is repaired Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


w/ Canister Pump Module:
(Click here)
w/o Canister Pump Module:
(Click here)

PROCEDURE

Hide 1.DRAIN ENGINE COOLANT (for Engine)

Hide G9200 2.REMOVE INVERTER WITH CONVERTER ASSEMBLY

Hide 25680 3.REMOVE EGR COOLER ASSEMBLY

a.
A423422C01
1.104,1.5 1.104,1.229 1.104,1.229 1.333,1.021 true 2.208,1.24 2.583,1.24 true 2.594,1.156 2.802,1.344 0.208,0.188 10 true *1 1.021,1.51 1.198,1.688 0.177,0.177 10 true *2
*1 No. 3 Water By-pass Hose
*2 No. 4 Water By-pass Hose


Slide the 2 clips and disconnect the No. 3 water by-pass hose and No. 4 water by-pass hose from the EGR cooler assembly.


b.
A405772

Remove the 5 bolts and EGR cooler assembly from the cylinder head sub-assembly and EGR valve assembly.


c.
A405773

Remove the EGR valve gasket from the EGR valve assembly.


d.
A405774

Remove the EGR cooler gasket from the EGR cooler assembly.