DTC C1241/41 Low Battery Positive Voltage or Abnormally High Battery Positive Voltage |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1241/41 | When any of following conditions detected:
|
|
| 1.INSPECT BATTERY |
Check the battery voltage.
| Result | Proceed to |
| OK | A |
| NG (for 2UZ-FE) | B |
| NG (for 3UR-FE) | C |
| NG (for 3UR-FBE) | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.INSPECT FUSE (ABS2) |
![]() |
Remove the ABS2 H-fuse from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ABS2 H-fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the A19 ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A19-47 (+BS) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A19-1 (GND1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.RECONFIRM DTC |
Clear the DTCs (Click here).
Start the engine.
Check if the same DTCs are output (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||